The 955WL earns high marks for strength. It's ideal for the same light-commercial uses as the Model 955. In addition, Trac-Rite's windlock system provides maximum wind resistance for this model. As wind blows against the 955WL, the curtain's windlocks engage with the door guide for a strong interlocking grip. This grip keeps the curtain securely in the guide. Available in custom sizes from 8'W up to 12'W x 3'H up to 12'8"H in 1" increments. Maximum heights vary depending on width. The 955WL features a 26-gauge, rigid-rib steel curtain that is durable, attractive, and requires little maintenance. The 955WL's drums and helical torsion EP3 springs provide solid curtain support and balancing; while the permanently-sealed ball bearings assure smooth operation.
Auto Body Shops
Fabric Span Structures
Post Frame Buildings
High Eave Structures with Relatively Low Door Heights
NOTE: Doors should not be used in applications that require fire rated or explosion proof doors. Heavy industrial and complex HVAC System (high negative or positive pressure) applications should also be avoided.
||Live axle: door axle rotates in bracket bearing during operation.|
||Stamped, continuously welded at the hub. 12" diameter x 1-1/2" wide. 16-gauge, zinc-coated steel. Three drums with doors up to 8' wide, four drums with doors over 8' wide.|
||Helical torsion, oil tempered, and coated to halt corrosion and increase life. One spring for all doors less than 5' high. One spring for doors 7'11" wide and smaller, two springs for doors 8' wide and larger.|
||Springs come with a zinc-coated cast steel tension wheel and winding bar for ease of adjusting spring tension.|
||1-5/16" outside diameter, schedule 80 steel pipe.|
||Roll-formed sections, factory-seamed from 26-gauge, Grade 80 galvanized steel. Siliconized polyester finish in eleven standard colors. Full-length felt tape at each drum.|
||10-gauge, zinc-coated steel, secured to door with two 3/16" rivets.|
||Zinc-coated steel bottom angle mounted to corrosion-resistant aluminum extrusion with stainless steel bolts. TPE blade astragal also included.|
||10-gauge, cold-formed, zinc-coated steel. Grease-packed ball bearings are factory installed in the bracket.|
||16-gauge, zinc-coated, 2-3/4" deep. Featuring polypropylene guide runners to assure smooth operation and prevent steel-on-steel contact. Guide windlock bar manufactured from 12-gauge, zinc-coated steel.|
||12-gauge, zinc-coated steel slide bolt engages a lock strike attached to the side guide. Two locks per door fasten to the bottom assembly and are suitable for padlocking.|
||Steel or wood fasteners included. Masonry fasteners sold separately.|
||12-gauge, zinc-coated, L-shaped door stops. Mounts to guides.|
|Pull Rope Handle
||Molded plastic rope handle with long-lasting rope.
Note: Product specifications are subject to change without notice.
Wind Load Ratings
All Trac-Rite door models, both standard and windlock, are put through rigorous wind testing. The testing is witnessed and certified by an independent test lab. Trac-Rite doors are approved for installation in buildings affected by Florida Building Commission regulations concerning wind testing and manufacturing certifications.
955WL Door Width 955WL Door PSF Rating
After reviewing the complete installation instructions, installing a Trac-Rite 955WL doors are easy to install!
- Assemble brackets and guides to door nest.
- Hoist door in place and attach brackets.
- Attach guides, tension the door, cut bands, and install door stops.
- Adjust and fasten guides. Install lock assembly and rope.
You're now ready to use your Trac-Rite 955WL door!
Order Your Door
Once you have completed the four preliminary steps for determining your needs, you are ready to order your 955WL door.